trakliner.blogg.se

1. RASPBERRY PI MAGIC MIRROR GUIDE TOUCHSCREEN INSTALL
2. RASPBERRY PI MAGIC MIRROR GUIDE TOUCHSCREEN ANDROID
3. RASPBERRY PI MAGIC MIRROR GUIDE TOUCHSCREEN SOFTWARE
4. RASPBERRY PI MAGIC MIRROR GUIDE TOUCHSCREEN BLUETOOTH

RASPBERRY PI MAGIC MIRROR GUIDE TOUCHSCREEN BLUETOOTH

The Magic Mirror also supports WiFi and Bluetooth 4.2. This IPS touch screen comes with a Raspberry Pi 3A+ controller, Ferrite Hi-Fi Speaker, microphone, and Snowboy Hotword detection engine. The Magic Mirror supports portrait and landscape layouts and displays weather updates, time, and news updates. The screen resolution is 1920×1080 pixels. It is an IPS display with 10-Point Capacitive Touch control. The 13.3-inch Magic Mirror comes with the Google (for English) and iFLYTEK (for Chinese) voice assistants. I bent a pin of spend 1 hour trying to work out why I had gobbledygook on the screen, and then another hour fixing the pin.Magic Mirror Voice Assist 1920x1080p 13.3 inch Capacitive IPS Touch Screen + Raspberry Pi 3A+ Controller + Card Reader + 16GB Micro SD Card + Charging Adapterĭownload User Guide for 13.3-inch Magic Mirror Be careful with this- this plugs designed for rigors of tampering. The stripping off the casing of your monitor (and wiring up USB power if you are going that route) might involve pulling out various plugs and wires.

If you do screw something else up: acetone, a plastic store card and patience (not anger!) unsticks double-sided 3M tape.

I had forgotten to replug some of the screen internal PCBs together. Before stick, check one last time that your screen is working okay. I stuck my screen to the back face of the glass with 3M tape. Important tips (to save yourself a lot of angst): Measure twice, cut once – or in this context, check twice, stick once:.Power your RaspPi from you monitor power supply.Paint the inside (non-visible parts) of your mirror frame black, plus put a black backing on the frame.It’s okay, but I suspect the effect would be better with a better screen, I used a crappy old (and small…but free!) Hyundai screen – the whites aren’t that bright and the black isn’t ‘black’ so you see the outline of the screen behind the glass. Source a good (2nd hand?) monitor with very black blacks and very vivid whites.Its power supply provided 12V and 5V, but the 5V was redundant so I wired a USB micro-B plug to it to power the Pi. Doing it as per instructions via terminal did not work for me.Īn old Hyundai monitor with case stripped off. Ignore the instruction in (5) for turning off screensaver – easier to do it via the GUI.Follow Magic Mirror installation guide this (near) word-for-word.

RASPBERRY PI MAGIC MIRROR GUIDE TOUCHSCREEN INSTALL

RASPBERRY PI MAGIC MIRROR GUIDE TOUCHSCREEN SOFTWARE

My tips would be: Software (with links where to find instructions) To build, follow the instructions in MagPi magazine (Issue #40) article, tailoring to suit.

It cost around 90 bucks (more than I wanted and expected to pay!) (In Auckland), I got 6mm (Pilkington) Mirropane™ from Howick Glass (who source from Metro Glass). Other than that you should be able to get it from your local glass merchant. A cautionary note: two-way mirror glass = pervert in most applications, unless you are in the interrogation business. The only thing I did not have was two-way glass.

RASPBERRY PI MAGIC MIRROR GUIDE TOUCHSCREEN ANDROID

In my (so far) unsuccessful quest to mirror & control my Android phone on a Raspberry Pi + touchscreen (for my car), I kept on coming across MagicMirror for Raspberry PI online. If this post is part of a series, there may be a more recent post that supersedes this one. The content here is probably outdated, so bear that in mind.